This commercial food service equipment is being sold by Online Auction on GovDeals.com.

Auction #16034-79, ending June 7, 2023.

To see full details, additional photos and current bid, please use this link - https://govdeals.bid/3MxkzRM

Brand New Hobart MG1532 Mixer Grinder

Removed from service date - Never put into service

Condition when removed from service - Working

Current condition - Working

Reason for being auctioned - No longer required

Quantity - 1 Mechanical/operational issues - None

 - 150 pound hopper capacity

 - Double wall construction

 - 7.5 H.P. grind motor and 1 H.P. mix motor

 - 8-foot cord and plug power connection

 - Separate mix and grind motorsPneumatic foot control

 - Hand removable and interchangeable seals

 - Counterbalanced lid

 - Double-sealed push button control panel with condensate heater

 - Easy access hopper interior and exterior surfaces

General: The MG1532 has a 7.5 H.P. grind motor, 1H.P. mix motor and an 8-foot length cord and plug power connection.

Casters, air-drive foot switch, drain pan and splash shield are standard. Available voltages are 208/60/3 and 480/60/3.

Electrical Controls: Electrical controls consist of front mounted water resistant switches, magnetic contactors, dual motor overload protection and foot switch operation capability.

An electrical interlock switch is provided. Whenever the hopper lid is opened, power to the motors is shut off. The hopper lid must be in its proper operating position before the motors can be started.

Capacity: The MG1532 Mixer-Grinder hopper has meat capacity up to 150 pounds depending on the type of product. The grinding rate is 35-40 pounds of fresh boneless meat per minute through 1⁄8" plate.

The MG1532 is for fresh or frozen meat tempered to 26°F. or higher and can be in flake or stick form.

Grinding End: The mixer-grinder is equipped with a “Wedge cylinder” grinding end. This grinding end is sized for #32 knives and plates (not included but optionally available).

Stay-Sharp Knives and Plates: The Hobart Stay-Sharp knife & plates are made from an alloy steel that holds its edge longer than standard carbon steel. Stay-Sharp plates also can be resharpened many more times than regular plates. These two features allow a substantial lifetime cost benefit with the Hobart Stay-Sharp plates.

Please see auction page for additional information and features.

***GovDeals.com - Bid on Government Auctions to buy Government Surplus.***